EL-150

7250P-005 / 91491Spark Igniter & Flame Rod Gasket

This is a gasket used on many HTP products to seal the spark ignitor and flame rod to the burner door.

7350P-020 Munchkin Spark Electrode

The Boiler Spark Ignitor generates the electric spark that begins combustion within many HTP boilers. Includes 7250P-005 gasket.

7500P-067 Nut M6 for Burner Door

 Nut M6 for Burner Door.

7500P-074 / 91552 Burner Gasket

This Boiler Burner Gasket is found of many HTP boilers and it helps seal the burner and air channel to the door.

7250P-667 / 91532 Thermistor

Thermistor.

7250P-653 / 91476 Munchkin Spark Cable

Spark cable.

7250P-378 / 91471 Control Board Fuse 110 Volt 6.3 AMPS

The 6.3 Amp Control Board Fuse is a slow-blow fuse in the control board that is designed to protect the product's electronics in some cases.

7250P-319 Munchkin Outdoor Sensor Vision 1

The Outdoor Temperature Sensor is used by many HTP Products to help enable warm weather reset as it enables greater efficiencies when it is warmer outside. This is included with all current HTP products.

7250P-160 / 91432 Ceramic Target Wall

The Ceramic Target Wall is a protective disk made up of ceramic fibers. It should always be in place when a boiler is being used, as it protects the back wall of the heat exchanger.

7250P-150 / 91498 Blocked Vent Pressure Switch

The block vent pressure switch is used to make sure that the exhaust from the product can safely exit through the vent.

7250P-096 / 91609 Water Pressure Switch

The water pressure switch is to help insure that there is sufficient water in the boiler when it is running. It should prevent the boiler from firing if it does not detect enough water.

7250P-069 Screw for Spark Electrode and Flame Rectification Probe

This screw is used when securing a flame problem or ignitor for many HTP products. It is a #2 Phillips M4 x 8mm made out of Stainless Steel and they are sold individually.