MC-80

7500P-092 / 91542 Swirl Plate

This swirl plate is used in Munchkin boilers to control the flow of incoming air to improve combustion.

7250P-653 / 91476 Munchkin Spark Cable

Spark cable.

7250P-644 / 91545 Adapter Plate

The Dungs Gas Valve to Blower Mounting Kit is used to connect a gas valve to a blower motor inside many HTP products.

7250P-319 Munchkin Outdoor Sensor Vision 1

The Outdoor Temperature Sensor is used by many HTP Products to help enable warm weather reset as it enables greater efficiencies when it is warmer outside. This is included with all current HTP products.

7250P-160 / 91432 Ceramic Target Wall

The Ceramic Target Wall is a protective disk made up of ceramic fibers. It should always be in place when a boiler is being used, as it protects the back wall of the heat exchanger.

7250P-150 / 91498 Blocked Vent Pressure Switch

The block vent pressure switch is used to make sure that the exhaust from the product can safely exit through the vent.

7250P-081 / 91427 Water Pressure Switch

This water pressure switch is used to insure that there is sufficient water in the boiler to operate.

7250P-080 / 91430 Relief Valve 3/4 MXF

The pressure relief valve is a safety on the boiler that will release above 30 PSI. The relief valve is rated for up to 510,000 BTU per hour.

7250P-069 Screw for Spark Electrode and Flame Rectification Probe

This screw is used when securing a flame problem or ignitor for many HTP products. It is a #2 Phillips M4 x 8mm made out of Stainless Steel and they are sold individually.

7250P-059 / 91435 Thermistor Inlet / Out-Let

A boiler water temperature sensor measure the temperature of the water and transmits that information to the control in the form of electrical resistance.